You are here

BLANKING AND SHEARING

 

Overview PPT : BLANKING AND SHEARING

 

#631 - Sartkulvanich, P., et al, "FEA of the effect of blanked edge quality upon stretch flanging of AHSS", Annals of CIRP-GA-2010, p.279-282

 

#620-5 - Kardes, N., & Altan, T., "Examining Edge Cracking in Hole Flanging of AHSS" - Part I, Stamping Journal, July/August, 2008, p. 18


#620-6 - Sartkulvanich, P., & Altan, T., "Examining Edge Cracking in Hole Flanging of AHSS" - Part II, Stamping Journal, September 2008, p. 22


#620-7 -Sartkulvanich, P., & Altan, T., "Examining Edge Cracking in Hole Flanging of AHSS" - Part III, Stamping Journal, October 2008, p. 16


#620-8 - Sartkulvanich, P., & Altan, T., "Examining Edge Cracking in Hole Flanging of AHSS" - Part IV, Stamping Journal, November 2008, p. 20



#642-9 - Subramonian, S., and Altan, T., Punch Wear in Blanking - Part I. Punch Geometry and Failure, Stamping Journal, July/August 2012, p.14.

 

#642-10 - Subramonian, S., and Altan, T., “Punch Wear in Blanking - Part II”, Stamping Journal Sept./Oct. 2012

 

#658 - Subramonian, S. et. al.,  (including Altan, T.) “Determination of forces in high speed blanking using FEM and experiments”, JMTP, Dec. 2013

 

#663 - Subramonian, S., et al., (including Altan, T.), “Optimum selection of Variable Punch - Die clearance to improve tool life in blanking non-symmetric shapes”, J. of Machine Tools and Manufacture, 2013, p. 63-7

 

#683-6 - Stemler, P., et al., "Impact of Servo Press Motion on Hole Flanging of High Strength Steels ", (SAE Paper No. 2017-01-0311)